en Fault, what to do?
36
Initial or existing,
irreversible clouding of
glass.
Glasses not dishwasher-proof,
only suitable for dishwasher.
Use dishwasher-proof glasses.
Avoid long steam phase (standing time after
wash cycle ends).
Use wash cycle at lower temperature.
Set water softening system according to the
water hardness (if required one setting
lower).
Use detergent with glass protection
component.
Rust spots on the cutlery. Cutlery not adequately rust-
resistant. Knife blades are
frequently more severely
affected.
Use corrosion-resistant cutlery.
Cutlery will also rust if rusting
parts are rinsed at the same time
(pan handles, damaged utensil
baskets, etc.).
Do not wash rusting parts.
Salt content in the rinsing water
too high, as salt dispenser lock
not fastened firmly or salt was
spilled while being refilled.
Fasten salt dispenser lock firmly or remove
spilled salt.
Appliance does not start. The mains fuse has tripped. Check mains fuse.
Power cord not inserted. Ensure that the power cord is plugged all
the way into the back of the appliance and
into the socket. Check that the socket
functions.
The appliance door has not been
shut properly.
Close the door.
Programme starts
automatically.
You did not wait until programme
ended.
Perform reset.
(See “Terminating the programme”).
The door is difficult to
open.
Child lock is activated. Deactivate child lock. (See instructions for
use at the back)
Door cannot be closed. Door lock has been activated. Close door with increased force.
Door cannot be closed due to
installation.
Check appliance installation: Door
or attached parts must close without
obstruction.
Cover on the detergent
dispenser cannot be
closed.
Detergent dispenser or cover
guide blocked by sticky detergent
residue.
Remove detergent residue.
Fault Cause Remedial action
To Next Page
Loading...
Need help?
General
