Siemens TK 52 SERIES - Switching on the appliance; Filling the system; Controls; Power switch

12
12
7 LED display
The various LEDs indicate the following:
H on The water tank is empty and
needstobelled.
I on Trays full:
Empty and replace them.
I ashing Traysmissing:
Reinsert them.
S on Run the service programme
(see “Service programme“)
S ashing Serviceprogrammein
operation
J ashing Turndialtog/h.
J on Turn dial to O.
Settings and displays
Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4.
You can check the water hardness by
asking your local water supplier.
Degree Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-15
16-23
24-30
1-13
14-27
28-42
43-54
●Switchtheappliancetostandby.
●Holddownthesteambutton
h for at
least 5 seconds. The number of LEDs 7a
H, b I, c S, d J that light up indicates
the selected water hardness.
●Pressthesteambuttonh repeatedly
untilthecorrectnumberofLEDsislit;e.g.
for a hardness of 3, the LEDs 7a, b and c
(H, I, S) light up.
●Pressthestandbybuttona once. The
selected number of LEDs should light
upbriey;thisindicatesthatthedesired
setting has been saved successfully.
Ifawaterlter(optionalextraOrderNo.
461732) is used, the water hardness should
be set to 1.
Note: If no button is pressed within 90
seconds, the appliance switches to stand-
by mode without saving the new settings.
In this case, the previous water hardness
setting is retained.
Theappliancemustberinsedwhenalter
isrstusedandafterchangingthelter.
●Fillthetankwithwateruptothe0.5l
mark.
●Placeasuitablecontainer(approx.0.5l)
under the nozzle 8.
●Setthedial6 to g/h.
●Whenwaterstopscomingoutofthe
nozzle 8, set the dial back to O.
●Fillthewatertankandthewaterpipes
(see “Switching on the appliance / Filling
the system“).
Adjusting the grinding unit
Sliding switch 15 adjusts the degree of
grinding,fromcoarsetone.
Warning
Adjust the grinding unit only while it is
running! Otherwise the appliance may be
damaged.
●PressthestrongcoffeebuttonK.
●Whilethegrindingunitisrunning,move
the sliding switch 15 to the desired posi-
tion:thesmallerthedots,thenerthe
grind.
i The new setting will not become apparent
until the second or third cup is brewed.
Tip: For dark roast coffee beans, choose a
coarsergrind;forlightroastbeans,selecta
nergrind.
Float
Theoat19 in the water tray 18 shows
when the tray needs emptying.
●Iftheoat19 is clearly visible, empty the
water tray 18.
en
en