Siemens TK 53... - Page 27

23
en
The LEDs for button h and H “Add water”
light up.
● Place one cleaning tablet in the duct 13.
● Fill the water tank with lukewarm water,
add descaling agent and dissolve com-
pletely (total liquid 0,5 litres)
or
pour prepared descaling mixture into the
water tank (total liquid 0,5 litres).
● Press the steam button h. The descaling
process begins. Duration approx. 10 min-
utes.Thedescalingsolutionowsintothe
water tray 18.
The J LED lights up.
● Place a suitable container (approx.
0,5 litres) under the nozzle 8.
● Set the dial 6 to g / h. The descaling
process begins. Duration approx. 5 min-
utes.Thedescalingsolutionowsintothe
container.
The I LED lights up.
● Empty and reinsert the grounds tray 17.
The steam button LED h lights up.
● Empty and clean the water tank 11,ll
with fresh water up to the “max” mark and
reinsert.
● Place a suitable container (approx.
0,5 litres) under the nozzle 8.
● Press the steam button h. The clean-
ingprocessbegins.Waterowsintothe
container.
The JLEDashes.
● Turn the dial 6 to “O”. The cleaning
process begins. Duration approx. 10 min-
utes.Liquidowsintothecoffeegrounds
tray 17 inside the appliance, then out
through the coffee outlet.
The I LED lights up.
● Empty, clean and reinsert the trays 17
and 18.
The appliance starts to heat up and is ready
for use once the LEDs for dispensing but-
tons 3 E and 4 F light up.
Important: If the service programme is
interrupted, e.g. due to a power cut, it is
vital that the appliance be rinsed before it is
used again.
The appliance must be ready for use.
The â and steam button hLEDsash.
● Rinse the water tank 11thoroughlyandll
with fresh water.
● Press the steam button h. The appliance
isrinsedandliquidowsintothetray.
The
J LED lights up.
● Hold a cup under the nozzle 8 and turn
the dial 6 to
g / h. Water runs into the
cup.
The
JLEDashes.
● Turn the dial 6 back to “O”.
The appliance rinses and is ready for use
again.
Anti-freeze
In order to avoid damage through cold
during transportation and storage, the appli-
ance must be emptied completely
rst.
The appliance must be ready for use.
● Remove, empty, and replace water tank.
● Place a large, narrow container under
nozzle 8.
● Press
h button.
● As soon as the LED J lights up, turn the
rotary button 6 to
g / h.
The appliance will release steam for a
while.
● When nozzle 8 stops releasing steam,
turn dial back to “O”.
● Turn off the appliance.