Siemens TK76K573 - Energy Saving Mode; Setting up the Appliance

38
deen
Energy saving mode
If the drip tray is not in place, the appli-
ance cannot be switched on and no water
ows out of the coffee outlet. The message
Replace drip tray appears. This message
also appears if the drip tray is removed
while the appliance is in “energy saving
mode”. The message disappears when the
drip tray is replaced. The appliance reverts
to “energy saving mode”.
Do not press the power switch
while the appliance is operating.
The appliance should only be
switched off when it is in “energy
saving mode”, so that it can rinse
automatically.
Setting up the appliance
1. Press the power switch (1).
1
2. The language selection is shown in the
display:
Sprache:
Deutsch
Start drücken
3. Press the retracted rotary knob (4)
and turn it to select the language in
which you want the display texts to
appear. The following languages can be
selected:
Deutsch Português
English Dansk
Pycckий Norsk
Nederlands Suomi
Français Česky
Italiano Türkçe
Svenska Magyar
Español Ελληνικά
Polski Български
4. Press start stop (8). The language
you selected is saved and the appliance
is in “energy saving mode”.
You can change the language setting at
any time (see “Displaying settings”).
5. Deploy the appliance (see “Deployment
system”).
6. Remove the water tank (12) by pulling
it upward, rinse and ll it with fresh cold
water. Do not ll above the “max” mark.
12
15
7. Replace the water tank and push it
rmly downward into place.
Fill the water tank with fresh water
every day. The tank should always
contain sufcient water for operat-
ing the appliance.
8. Fill the bean container (15) with coffee
beans (for preparation using ground
coffee, see page 40).
9. Push the appliance back into the built-in
unit.
www.devicemanuals.eu