44
deen
Information and settings
Use i (7) to display information (press
briey) and adjust settings (hold down for at
least three seconds).
Displaying information
In the Info menu (press i (7) briey) you
can call up the following information:
► when it is necessary to descale the
appliance
► when it is necessary to clean the
appliance
► when it is necessary to change the lter
► how much coffee has been dispensed
since the appliance was rst put into
operation
► how many milk drinks have been
dispensed
► how much hot water has been prepared
Information / Service
Descale after
100 cups
Displaying settings
Hold down i (7) for at least 3 seconds;
the different setting options are then
displayed:
Language:
English
Per-cup quantities
Default settings
Use < and > (3) to switch between
the different setting options. The currently
active setting is always highlighted in white.
You can change the setting that is currently
displayed by turning the rotary knob (4).
To exit the menu, press i (7) again.
The changes you have made
are saved automatically. It is
not necessary to conrm them
additionally.
The following setting options are available
to you:
> Language: Turn the knob (4) to
select the display language.
> Per-cup quantities: The per-cup
quantity can be set separately for each
type of drink and each cup size (see “Set
per-cup quantity” on page 45).
> Water hardness: Turn the knob
(4) to select the required water hardness
(1, 2, 3 or 4) (refer also to “Checking and
setting the water hardness”).
> Coffee temperature: Turn the knob
(4) to set the coffee temperature.
> Auto off after: Turn the knob
(4) to enter the time span after which the
appliance should automatically switch off
following the last drink preparation.. A time
between 5 minutes and 8 hours can be set.
The default time is one hour, but this can be
shortened to save energy.
> Contrast: The display contrast can
be set from –20 to +20 with the rotary knob
(4). The default setting is 0.
> Illumination: The lighting can be
set to Off, On or Off after 5 min. (factory
setting: On).
> Water filter: Each time a new water
lter is inserted in the water tank (12), it
must be rinsed:
1. Place the water lter in the water tank
(12) and ll the tank with water up to the
“max” mark.
2. Turn the rotary knob (4) to select
Press start and press start stop
(8).
3. Place a container with a capacity of
0.5 litres under the milk frother (10).
4. Press start stop (8). Water will now
run rst through the lter to rinse it and
then into the container.
To Next Page
Loading...
