Siemens WG44G2AXES - Page 43

Troubleshooting en
43
Fault Cause and troubleshooting
"E:30 / -10" and/or 1. First wait approx. 5 minutes until the drain process
ends.
2. To reset the error message, switch the appliance
off.
3. Switch the appliance back on.
4. If the error message is displayed again, call cus-
tomer service.
→"Customer Service", Page53
"E:35 / -10" There is water in the base trough.
▶ Turn off the water tap.
▶ Call the after-sales service.
→"Customer Service", Page53
The appliance is leaking.
▶ Turn off the water tap.
▶ Call the after-sales service.
→"Customer Service", Page53
The detergent drawer has not been pushed in fully.
▶ Push in the detergent drawer until the symbol goes
out.
The pump unit is not inserted.
1. Insert the pump unit into the detergent drawer.
→"Cleaning the detergent drawer", Page36
2. Push in the detergent drawer until the symbol goes
out.
lights up. The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page32
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page25
flashes. Door is not closed.
1. Close the door.
2. Press inicio pausa + carga to start the programme.
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press inicio pausa + carga to start the programme.