Siemens WG44G2MG0 - Page 39

Troubleshooting en
39
Fault Cause and troubleshooting
lights up. 4. Press Start/Nachlegen to start the programme.
flashes. Door is not closed.
1. Close the door.
2. Press Start/Nachlegen to start the programme.
All other error codes. Malfunction
▶
Call the after-sales service.
→"Customer Service", Page47
"E:30/-20" Solenoid valve defective.
▶
Call the after-sales service.
→"Customer Service", Page47
Detergent dosage is too high.
▶
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Additional water is added.
▶
Do not add any extra water to the appliance while it
is operating.
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The programme does
not start.
You have not pressedStart/Nachlegen.
▶
Press Start/Nachlegen.
Door is not closed.
1. Close the door.
2. Press Start/Nachlegen to start the programme.
Childproof lock is activated.
▶
→"Deactivating the childproof lock", Page32
Fertig in is activated.
▶
Check whether Fertig in is activated.
→"Buttons", Page22
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press Start/Nachlegen to start the programme.