Positioning and connecting en
19
Transportation
e.g. when moving home
Preparatory work:
1. Turn off the water tap.
2. Reduce the water pressure in the
supply hose.
~ "Filter in the water supply is
blocked" on page 37
3. Drain the remaining detergent
solution.
~ "Drain pump is blocked"
on page 36
4. Disconnect the washing machine
from the mains.
5. Remove the hoses.
Installing the transport locks:
1. Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2. Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
■ The transport locks must be
removed.
~ "Removing the transport locks"
on page 14
■ To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment II and start
the Drain/Empty programme.
To Next Page
Loading...
