en Operating the appliance
32
Cancelling the programme
For programmes at high temperature:
1. Press the I button.
2. To cool down laundry: Select Rinse.
3. Press the I button.
For programmes at low temperature:
1. Press the I button.
2. Select Drain/Empty.
3. Press the I button.
Programme end during Rinse
Stop
- - - 0 appears in the display panel
and the indicator lamp of the I button
flashes.
Continue the programme by:
■ Pressing the I button (the laundry
will be spun with the default spin
speed setting
*
) or
■ Selecting a spin speed or setting the
programme selector to Drain/Empty
and then pressing the I button.
Programme end
“Ÿš appears in the display panel and
the indicator lamp of the I button
goes out.
Removing laundry/switching
off the appliance
1. Turn the programme selector to the
off position. The appliance is
switched off.
2. Open the door and remove the
laundry.
3. Turn off the tap.
Note: Not required for Aqua-Stop
models.
Notes
■ Always wait until the programme
ends, as the appliance could still be
locked.
■ At the end of the programme, the
appliance switches to energy saving
mode. The lighting goes out and the
I button flashes. Press any button
to activate the panel.
■ Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■ Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■ Wipe the rubber seal and the
washing machine door dry.
■ Leave the door and detergent
drawer open so that any residual
water can evaporate.
* depending on the chosen
programme ~ Overview of
programmes on supplementary
sheet for the operating and
installation instructions
To Next Page
Loading...
Need help?
General
