Siemens WM14E462GB series - Faults and what to do about them.; Water is leaking out.; No water supply.; Detergent is not dispensed.

Faults and what to do about them. en
25
Information on the display panel
Faults and what to do about them.
Display Cause/remedial action
YES The washing machine door is unlocked. It is possible to add laundry.
NO ■ Temperature too high. Wait until the temperature drops.
■ Water level too high. Not possible to add laundry. Close the washing machine
door immediately, if necessary. Select Start/Reload to continue the pro-
gramme.
NO flashes ■ Wait until YES + v light up.
■ Note: Do not open the washing machine door until both the symbols YES + v
light up.
F:16 Close the washing machine door properly; washing may be trapped.
F:17 ■ Turn the water tap on fully,
■ Supply hose kinked or trapped,
■ Water pressure too low. Clean the filter. ~ Page 23
F:18 ■ Detergent solution pump blocked. Clean the detergent solution pump.
~ Page 22
■ Drain hose/waste pipe blocked. Clean the drain hose on the siphon.
~ Page 23
F:21 Motor fault. Call the after-sales service. ~ Page 27
F:23 Water in the base trough, appliance leaking. Call the after-sales service.
~ Page 27
u Childproof lock activated; deactivate it. ~ Page 19
x flashes Too much foam detected, a rinse cycle has been switched on ~ Page 20
Faults Cause/remedial action
Water is leaking out. ■ Attach/replace the drainage hose correctly.
■ Tighten the screw connection of the supply hose.
No water supply.
Detergent is not dis-
pensed.
■ Start/Reload not selected?
■ Tap not turned on?
■ Filter blocked? Clean the filter.
■ Supply hose kinked or trapped?
Washing machine door
cannot be opened.
■ Safety function active. Programme stopped?
■ 2 (without final spin) selected?
■ Can be opened by emergency release only?
Programme does not
start.
■ Start/Reload or Finished in time selected?
■ Washing machine door closed?
■ u Childproof lock activated? Deactivate it.