How to improve insufficient cleaning with Siemens WM14UPHSES?
If your Siemens washer isn't cleaning sufficiently: * If intelligent dosing is activated, adjust the basic dosage. * Check whether the detergent used is suitable. Drain the dispenser, clean it, and refill it if detergent or care products have congealed in dispensers of the intelligent dosing system.
How to fix E:36 / -10 error on Siemens WM14UPHSES Washer?
The E:36 / -10 error may appear on your Siemens washer for several reasons. Try these solutions: * Clean the drain pipe and the water outlet hose, as they might be blocked. * Ensure that the drain pipe and water drain hose are not kinked or trapped. * Install the water outlet hose at a maximum height of 1 metre. * Correctly assemble the pump cover. * If the detergent dosage is too high, mix one tablespoon of fabric softener with 0.5 litres of water and pour the mixture into the compartment for manual dosing (not for outdoor clothing, sportswear or items stuffed with down). * If intelligent dosing is activated, reduce the basic dosage; if you dose manually, reduce the amount of detergent for the next washing cycle with the same load.
What to do if my Siemens Washer shows error code E:30 / -10?
The E:30 / -10 error on your Siemens washer could be due to several reasons. Check the following: * Ensure that the water inlet hose is not kinked or jammed. * Clean the water inflow filter if it is blocked. * Turn on the tap if it is turned off. Additionally, if the pump for the intelligent dosing system is blocked: 1. Switch off the appliance. 2. Clean the pump unit. 3. Switch the appliance on. 4. If the display appears again after you clean the pump unit, call customer service.
Why Siemens Washer shows H:32 error?
The H:32 error code on your Siemens washer indicates that the unbalanced load detection system has interrupted the spin cycle because the laundry is unevenly distributed. To resolve this, redistribute the laundry in the drum.
What to do if Siemens WM14UPHSES display goes out and flashes?
If the display on your Siemens washer goes out and flashes, it may be because the energy-saving mode is active. Press any button to exit this mode.
What does E:35 / -10 mean on my Siemens Washer?
If your Siemens washer displays the error code E:35 / -10, it indicates there is water in the base trough. Turn off the water tap and call the after-sales service.
To Next Page
General