Siemens WM14UPHSES - Setting up Home Connect; Activating Wi-Fi on the Appliance; Deactivating Wi-Fi on the Appliance; Resetting the Appliance Network Settings

HomeConnect en
37
16.2 Setting up HomeCon-
nect
Requirements
¡ The HomeConnect app is installed
on your mobile device.
¡ Wi-Fi has been activated on the
router.
¡ The appliance is receiving signals
from the WLAN home network (Wi-
Fi) at its installation location.
1. Use the HomeConnect app to
scan the QR code.
2. Follow the instructions in the
HomeConnect app.
16.3 Activating Wi-Fi on the
appliance
Note:When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1. Press and hold for approx. 3
seconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press repeatedly until the dis-
play shows On.
a Wi-Fi is activated.
Note:If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
16.4 Deactivating Wi-Fi on the
appliance
1. Press and hold for at least
threeseconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press repeatedly until the dis-
play shows OFF.
a Wi-Fi is deactivated.
Note:The connection is automatically
re-established when the Wi-Fi is
switched back on.
16.5 Resetting the appliance
network settings
1. Press and hold for at least
3seconds.
2. Set the programme to position5.
a The display shows rES.
3. Press .
a The display shows YES.
4. Press .
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
16.6 Remote start
Enable the appliance for remote start
via the HomeConnect app.
Activating remote start
Notes
¡ Remote start is deactivated for
safety reasons in the following
circumstances:
– Open the appliance door.
– Press .
– Press .
– Switch off the appliance.
– Following a power cut.