Siemens WM14UPHSES - Filling the Dispensers

Intelligent dosing system en
35
15.2 Filling the dispensers
If you want to use the intelligent dos-
ing system or if the appliance dis-
plays a notification during operation
of the appliance, fill the dispensers.
Note:Fill the dispensers only with
suitable detergent and care products
→Page31.
If you want to add more liquid deter-
gent or fabric softener in the dis-
penser, use the same product.
If you want to replace the liquid de-
tergent or fabric softener in the dis-
penser with another product, clean
the detergent drawer beforehand.
→"Cleaning the detergent drawer",
Page40
If you want to use both dispensers
for liquid detergent, adjust the con-
tents of the dispensers →Page35.
Requirement:The display shows a
notification to fill the dispenser.
→"Display", Page21
→"Display", Page21
1. Pull out the detergent drawer.
2. Open the dispenser cover.
3. Pour liquid detergent and fabric
softener into the relevant dis-
pensers.
→"Detergent drawer", Page17
Do not exceed the marking for the
maximum fill level when filling.
4. Close the dispenser cover.
Note:To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
5. If required, pour washing aid into
the compartment for manual dos-
ing.
→"Adding detergent and care
product", Page32
6. Push in the detergent drawer.
7. Adjust the basic dosage
→Page36.
15.3 Dispenser contents
Notes
¡ If you change the contents of the
dispenser, the basic dosage for
this dispenser is reset.
¡ If you use both dispensers for li-
quid detergent, you must select a
dispenser which is to be used dur-
ing washing.
Adjusting the dispenser contents
1. Press and hold ⁠i-Dos for ap-
prox. 3 seconds.