Siemens WM14VG43 - Adjusting the Programme Settings; Saving the Programme Settings; Loading Laundry; Inserting the Measuring Aid for Liquid Detergent

operation en
33
13.3 Adjusting the pro-
gramme settings
Requirement:A programme has
been set.
→"Setting a programme", Page32
▶
Adjust the programme settings.
→"Buttons", Page24
Observe the information about op-
erating logic →Page18.
Note:The programme settings are
not saved permanently for the pro-
gramme.
Adjusting additional programme
settings
1. Press Optionen to call up addi-
tional programme settings.
2. Select the programme settings.
3. Press Optionen to call up the main
menu.
13.4 Saving the programme
settings
1. Set the Memory programme.
2. Press to call up the sub-
menu.
3. Select a programme.
4. Press Main menu to call up the
main menu.
5. Adjust the programme settings if
required.
a The programme is saved.
13.5 Loading laundry
Note:To prevent creasing, take note
of the maximum load for the
→"Programmes", Page27.
Requirement:The laundry is pre-
pared.
→"Laundry", Page31
1. Open the door.
Make sure that the drum is empty.
2. Place the laundry in the drum.
3. Close the door.
Ensure that there is no laundry
trapped in the door.
13.6 Inserting the measuring
aid for liquid detergent
If you order the measuring aid as an
accessory, you must use the measur-
ing aid.
1. Pull out the detergent drawer.
2. Press down on the insert and re-
move the detergent drawer.
3. Insert the measuring aid.
4. Insert the detergent drawer.