Siemens WM14VPH9GB - Starting the Programme; Soaking Laundry; Adding Laundry; Cancelling the Programme

en Basic operation
36
4. Push in the detergent drawer.
Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press Start/ Reload.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a If you start a programme with act-
ive oxygen, the drum lights up
after the programme starts and the
mist that is created can be seen.
a After the programme has ended,
the display shows: End.
Soaking laundry
You can soak the laundry before
washing in the appliance by pausing
the programme.
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press Start/ Re-
load.
3. To resume the programme, after
the desired soaking time, press
Start/ Reload.
Adding laundry
Notes
¡ Please read the safety information
→Page4 to ensure that you use
the appliance safely.
¡ If you a start a programme with
active oxygen, you cannot add any
laundry after the programme has
started.
1. Press Start/ Reload.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
→"Display", Page20
2. Add or remove laundry.
3. Close the door.
4. Press Start/ Reload.
Cancelling the programme
Once the programme has started,
you can cancel it at any time.
Notes
¡ Please read the safety information
→Page4 to ensure that you use
the appliance safely.
¡ If you cancel a programme with
active oxygen, the door will remain
locked for up to 25 minutes until
there is no longer any active oxy-
gen in the drum. and flash
while the active oxygen is being re-
moved. The door is then unlocked.
1. Press Start/ Reload.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high: Start
the Spin or Drain programme.
3. Remove the laundry.
Resuming the programme when
the programme status is Rinse
Hold
1. Set the Spin or Drain programme.
2. Press Start/ Reload.