Siemens WM14VPH9GB - Activating Wi-Fi on the Appliance; Deactivating Wi-Fi on the Appli- Ance; Software Update; Resetting the Appliance Network Settings

HomeConnect en
41
4. Press Start/ Reload.
a The display shows and Flex Start
is activated. The appliance waits to
be started by the smart energy
system (energy manager).
a If the time changes on the display,
e.g. to 8 h, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡ Press Start/ Reload.
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
Activating Wi-Fi on the appli-
ance
Note:When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1. Press and hold Remote Start for
approx. 3 seconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press Start/ Reload repeatedly
until the display shows On.
a Wi-Fi is activated.
Note:If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
Deactivating Wi-Fi on the appli-
ance
1. Press and hold Remote Start for
at least threeseconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press Start/ Reload repeatedly
until the display shows OFF.
a Wi-Fi is deactivated.
Note:If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
Software update
Requirement:The display shows
UdP.
1. Press and hold Remote Start for
approx. 3 seconds.
2. Set the programme to position6.
a UPd appears on the display.
3. Press Start/ Reload.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note:The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
Resetting the appliance network
settings
1. Press and hold Remote Start for
at least 3seconds.
2. Set the programme to position5.
a The display shows Start /Reload.
3. Press Start/ Reload.
a The display shows YES .
4. Press Start/ Reload.
a The network settings are reset.