Siemens WM16XKH2ES - Dispenser Contents; Basic Dosage

Intelligent dosing system en
35
If you want to replace the liquid de-
tergent or fabric softener in the dis-
penser with another product, clean
the detergent drawer beforehand.
→"Cleaning the detergent drawer",
Page40
If you want to use both dispensers
for liquid detergent, adjust the con-
tents of the dispensers →Page35.
1. Pull out the detergent drawer.
2. Open the dispenser cover.
3. Pour liquid detergent and fabric
softener into the relevant dis-
pensers.
→"Detergent drawer", Page19
Do not exceed the marking for the
maximum filling level when filling.
4. Close the dispenser cover.
Note:To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
5. If required, add cleaning aids such
as stain remover, water softener or
bleach into the compartment for
manual dosing.
→"Adding detergent and care
product", Page32
6. Push in the detergent drawer.
7. Adjust the basic dosage
→Page35.
15.3 Dispenser contents
Notes
¡ If you change the contents of the
dispenser, the basic dosage for
this dispenser is reset.
¡ If you use both dispensers for li-
quid detergent, you must select a
dispenser which is to be used dur-
ing washing.
Adjusting the dispenser contents
1. Press and hold for approx. 3
seconds.
2. To set , press .
a The display shows .
3. To set , press again.
4. To end the setting process, wait
briefly.
15.4 Basic dosage
The basic dosage depends on the
manufacturer's instructions for the de-
tergent, the water hardness and the
degree of soiling of the laundry.
Always set a basic dosage that cor-
responds to the dosage for a stand-
ard load of 4.5 kg. Detergent dosage
Adjusting the basic dosage
1. Press and hold for approx. 3
seconds.
a The display shows the basic
dosage set for .
2. To adjust the setting, press -/+.