en HomeConnect
38
2. Press inicio/pausa+carga.
a The appliance connects to the
HomeConnect app.
3. Once your appliance is displayed
in the HomeConnect app, carry
out the last steps in the
HomeConnect app.
a If the display shows , the appliance
is connected to the HomeConnect
app.
16.4 Activating Wi-Fi on the
appliance
Note:When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1. Press and hold for approx. 3
seconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press inicio/pausa+carga re-
peatedly until the display shows
On.
a Wi-Fi is activated.
Note:If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
16.5 Deactivating Wi-Fi on the
appliance
1. Press and hold for at least
threeseconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press inicio/pausa+carga re-
peatedly until the display shows
OFF.
a Wi-Fi is deactivated.
Note:The connection is automatically
re-established when the Wi-Fi is
switched back on.
16.6 Resetting the appliance
network settings
1. Press and hold for at least
3seconds.
2. Set the programme to position5.
a The display shows rES.
3. Press inicio/pausa+carga.
a The display shows YES.
4. Press inicio/pausa+carga.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
16.7 Remote start
Enable the appliance for remote start
via the HomeConnect app.
Activating remote start
Notes
¡ Remote start is deactivated for
safety reasons in the following
circumstances:
– Open the appliance door.
– Press inicio/pausa+carga.
– Press .
– Switch off the appliance.
– Following a power cut.
¡ Remote start cannot be activated
for safety reasons in the following
circumstances:
– The appliance door is open.
– The detergent drawer has not
been pushed in fully.
Requirements
¡ The appliance is connected to your
Wi-Fi home network.
¡ The appliance is connected to the
HomeConnect app.
¡ A programme is selected.
▶
Press .
If you press and hold the button
for at least 3seconds, the
HomeConnect menu opens.