Siemens WMH4Y890GB - Programme Management; Programme: Changing or Cancelling

en Operating the appliance
44
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1. Press the Ü button.
2. Select another programme.
3. Press the Ü button. The new
programme starts from the
beginning.
Cancel the programme
For programmes at high temperatures:
1. Press the Ü button.
2. To cool down laundry: Select Rinse.
3. Press the Ü button.
For programmes at low temperatures:
1. Press the Ü button.
2. Select Spin or Drain .
3. Press the Ü button.
Programme end during rinse
hold
The following appears on the display
panel:
Continue the programme by:
■ Select the Spin (change the spin
speed if necessary) or the Drain
programme.
■ Press the Ü button.
Programme end
ÏFinished, remove washing appears
on the display panel. The Ü button
indicator lamp is off.
Removing laundry/switching
off the appliance
1. Open the loading door and remove
the laundry. Follow the information
on the display panel.
2. Press the # button. The appliance is
switched off.
3. Turn off the tap.
Note: Not required for AquaStop
models.
Notes
■ Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■ Remove any foreign objects from the
drum and the rubber gasket – risk of
rusting.
■ Wipe the rubber gasket dry.
Notes
■ Leave the loading door and
detergent drawer open so that any
residual water can evaporate.
■ Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
■ If the display panel goes off at the
end of a programme, the energy-
saving mode is active. Press any
button to activate the panel.
%DE\QDKUXQJ
7RPDWH
6HOHFWVSLQRUGUDLQ
5LQVHKROGUHDFKHG
DQGWKHQVWDUW
6SLQ
3XPS