Siemens WMH4Y890GB - Updating the Software

Home Connect en
55
Updating the software
You can update the
Home Connect software on your
appliance. As soon as a new update is
available, a note appears in the display
panel for your appliance.
You can install the update directly via
the message on the display panel or via
the appliance settings.
1. Switch the appliance on.
2. Press and hold the Remote start }
button for more than three seconds.
Aut. network log-in appears in the
display panel.
3. Use either of the left-hand arrow
buttons to select Software update.
4. Use either of the right-hand arrow
buttons to select Install now.
Update installation will now start. This
process may take several minutes. Do
not switch the appliance off while
updates are being installed.
5. You can exit the Home Connect
settings by selecting the Remote
start } button.
Note: If no software update is available,
Not available appears in the display
panel. The Home Connect software is
completely up-to-date.
9HUELQGHQPLW$SS QLFKWYHUEXQGHQ
+DXSWPHQ
6RIWZDUHXSGDWH $YDLODEOH
1HWZRUNVHWWLQJV ,QVWDOOQRZ
9HUELQGHQPLW$SS
YHUELQGHQ
+DXSWPHQ
6RIWZDUHXSGDWH ,QVWDOOQRZ
1HWZRUNVHWWLQJV
$YDLODEOH