Siemens WU12UT61ES - Connecting the Appliance

Installation and connection en
15
4.5 Connecting the appliance
Connecting water inlet hoses
1. Connect the water inlet hose for
hot water and cold water to the ap-
pliance.
2. Connect the water inlet hose for
hot water and cold water to the tap
(26.4 mm = 3/4").
If there is no water tap for hot wa-
ter, only connect the water inlet
hose for cold water. Cover the hot
water connection on the appliance
in order to protect it from dirt.
3. Open the water taps carefully and
check that the connection points
are tight.
Water outlet connection types
This information is intended to help
you to connect this appliance to the
water outlet.
ATTENTION!
When draining, the water outlet hose
is subject to water pressure and may
come loose from the installed con-
nection point.
▶ Secure the water outlet hose
against unintentional loosening.
Note:Observe the draining heights.
The maximum draining height is
100cm.
Siphon Secure the con-
nection point with
a (24–40 mm)
hose clamp.
Sink Fix and secure
the water outlet
hose with an el-
bow
→Page28.
Plastic pipe with
rubber sleeve or
gully
Fix and secure
the water outlet
hose with an el-
bow
→Page28.