Siemens WU12UT61ES - Adding Laundry; Cancelling the Pro- Gramme; Resuming the Programme When the Programme Status Is Rinse Hold; Unloading the Laundry

en operation
32
2. To pause the programme, after ap-
prox. 10 minutes, press inicio/
pausa+carga.
3. To resume the programme, after
the desired soaking time, press
inicio/pausa+carga.
13.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:A programme has
started.
→"Starting the programme", Page31
1. Press inicio/pausa+carga.
The appliance pauses.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page22
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press inicio/pausa+carga.
13.12 Cancelling the pro-
gramme
1. Press inicio/pausa+carga.
2. Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the programme.
– If the water level is high, start
the programme or select a
suitable programme for draining.
→"Programmes", Page24
3. Remove the laundry.
→"Unloading the laundry",
Page32
13.13 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→"Buttons", Page23
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1. Set the programme or a pro-
gramme for draining the water.
→"Programmes", Page24
2. Press inicio/pausa+carga.
13.14 Unloading the laundry
1. Open the door.
2. Remove the laundry from the
drum.
13.15 Switching off the appli-
ance
1. Turn the programme selector to .
2. Turn off the tap.
3. Wipe the rubber gasket dry and re-
move any foreign objects.
4. Leave the appliance door and de-
tergent drawer open so that resid-
ual water can evaporate.