Siemens WU14UTG0 - Page 51

Troubleshooting en
51
Fault Cause and troubleshooting
flashes. Door is not closed.
1. Close the door.
2. Press Start/Nachlegen to start the programme.
All other error codes. Malfunction
▶
Call the after-sales service.
→"Customer Service", Page59
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The programme does
not start.
You have not pressedStart/Nachlegen.
▶
Press Start/Nachlegen.
Door is not closed.
1. Close the door.
2. Press Start/Nachlegen to start the programme.
Childproof lock is activated.
▶
→"Deactivating the childproof lock", Page41
Fertig in is activated.
▶
Check whether Fertig in is activated.
→"Buttons", Page23
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press Start/Nachlegen to start the programme.
The door cannot
beopened.
–––– is activated.
▶
Continue the programme by selecting Schleudern
or Abpumpen and pressing Start/Nachlegen.
→"Resuming the programme when the programme
status is Rinse Hold", Page40
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page40
Water level is too high.
▶
Start the Abpumpenprogramme.
Power failure.