AirLink
®
LS300 Quick Start Guide
Page 1
© 2013 Sierra Wireless All Rights Reserved PN 2400272 Rev. 1
This guide provides instructions for quickly getting your Sierra Wireless
®
LS300 device con gured and connected.
For more information refer to the:
• AirLink LS300 User Guide
• ALEOS
™
Con guration User Guide
Both are available for download from the Sierra Wireless web site (www.sierrawireless.com/Support/Downloads).
1 Remove the rear panel access cover.
2 Slide the SIM card into the SIM card holder.
Note the location of the notched corner for correct alignment.
3 Re-attach the cover.
STEP 1 Install the SIM Card (Does Not Apply to CDMA Devices)
STEP 2 Connect and Turn On the Device
1 Connect the RF antenna.
2 If required, connect the GPS and/or the diversity antenna (recommended).
3 If required by your application,
connect the RS-232 port and/or the
USB port.
4 Connect a Windows
®
computer to the device with an Ethernet cable.
5 Connect the power cable to the device.
The device starts automatically, as indicated by the ashing LEDs.
NOTE: If you want to con gure all your devices at the same time using AirVantage
®
Management Service, follow the instructions on page 2 to
register your devices before applying power.
To Next Page
Need help?
General
