SIG J-3 CUB - User Manual

This model of the famous Piper Cub is a natural for radio control, but can also be flown free flight - an increase in dihedral is
recommended for this application -
or converted to control line by the addition of leadout guides to the wing tip and a bellcrank in
the cabin. The stable flight characteristics make it a good RC scale trainer for inexperienced fliers, but it can be stunted by expert
expert pilots. Built-up construction is strong and light, will not be difficult if you study the plans and the instructions in this manual
carefully. Read all of the manual before beginning construction.

Summary

WING PANELS

WING CENTER SECTION

ELEVATOR AND STABILIZER

FIN AND RUDDER

FUSELAGE

LANDING GEAR

COWLING

DOPING AND DECORATION

DKM STIK-TITE PRESSURE SENSITIVE DECALS

Apply decals using a wet method with soapy water for a smooth, bubble-free finish.

RADIO EQUIPMENT INSTALLATION

PRE-FLIGHT

RECOMMENDED CONTROL SURFACE MOVEMENTS

Guidelines for elevator, aileron, and rudder movements for safe initial test flights.

BALANCING

FLYING

WARNING - DANGER!

Critical safety warnings for operation, including electrocution, propellers, fuel, and loss of control.

SIG J-3 CUB Specifications

General

Brand	SIG
Model	J-3 CUB
Category	Toy
Language	English