SIGLENT
SDG2000X User Manual 23
2.2 To Set Square Waveform
Press Waveforms key to select the waveform function, and press the Square
softkey. The square waveform parameters are set by using the Square
operation menu.
The parameters of square waveforms include frequency/period,
amplitude/high level, offset/low level, phase and duty. As shown in Figure 2-6,
select DutyCycle. The duty cycle parameter area is highlighted in the
parameter display window, and users can set the duty cycle value here.
Figure 2-6 Square Parameters Display Interface
Table 2-2 Menu Explanations of Square Waveform
Set the signal frequency or period;
The current parameter will be switched at a second press.
Set the signal amplitude or high level;
The current parameter will be switched at a second press.
Set the signal offset or low level;
The current parameter will be switched at a second press.
Set the phase of the signal.
Set the duty cycle for square waveform.
To Next Page
Loading...
Need help?
General
