SIGLENT SPS5041X User Manual

SPS5000X Series User Manual
WWW.SIGLENT.COM 0
SPS5000X Series
Wide Range Programmable
Switching DC Power Supplies
User Manual

SIGLENT SPS5041X Specifications

General

Brand	SIGLENT
Model	SPS5041X
Category	Power Supply
Language	English

Summary

Important Safety Information

General Safety Summary

Provides essential safety precautions for instrument operation and user protection.

Safety Terms and Symbols

Explains the meaning of safety symbols and terms used in the manual.

Working Environment

Cooling Requirements

AC Power and Ground Connections

Abnormal Conditions

Introduction of SPS5000X Series

Performance and Features

Model Introduction

SPS5000X Series Overview

Front Panel Controls and Display

Rear Panel Connections

CC and CV Mode Operation

Alarms and Protection Functions

Important Usage Considerations

Reverse Current Regenerative Loads

Reverse Current Protection Methods

Grounding Considerations

Switch On/Off and Output Port

Connecting the Power Cord

Power On and Power Off Procedures

Details the steps for turning the power supply on and off safely.

Power Off Safety Warnings

Output Port Configuration

User Interface Overview

Basic Operation

System Settings and Upgrade

Parallel/Series Operation

Channel Parallel or Series Configuration

Three-Channel Combination Modes

Function Settings

Setting the List Function

OCP/OVP Protection Settings

CC/CV Priority Mode Selection

External Analog Control

External Control Modes

External Control Output On/Off

Multi-channel Settings

Communication Interface Settings

GPIB Communication

LAN Communication and IP Settings

Remote Control

Remote Control Methods (NI-VISA)

Introduces remote control via NI-VISA, including connection methods.

Remote Control via Sockets

Grammatical Conventions for SCPI

Command Description

IEEE Common Command Subsystem

Measure Command Subsystem

Configure Configuration Command Subsystem

Voltage and Current Slope Settings

Response Mode Settings

Control Mode Settings

Output Status and Control

Output Delay and Enable State

Internal Resistance and CC/CV Priority

List Configuration Command Subsystem

List Step Voltage and Current Configuration

List Step Running Time and Delay Configuration

System Configuration Command Subsystem

Network and DHCP Settings

Subnet Mask, Gateway, and MAC Address Settings

Factory and Default Data Restoration

Master-Slave Series-Parallel Mode Configuration

Web Service Operation

Initial Network Connection Setup

Guides on setting up the PC and instrument for initial network connection.

SPS Power Supply Network Configuration

Web Interface Operation

List Operation Method via Web Interface

Explains how to configure list sequences using the web interface.

Troubleshooting Guide

Power-On and Display Issues

Provides steps to resolve issues where the power supply does not turn on or display anything.

No Voltage Output Issues

USB Device Recognition Problems