Sigma 6000+ - Page 32

TROUBLE SHOOTING GUIDE (CONTINUED)
PROBLEM
POSSIBLE CAUSE CORRECTION.
“SHUT DOOR" alarm
a. Door latch not completely seated. . Insure door latch is fully seated.
b. Door latch magnet . Insure polarity correct.
©. Door sensor inop. . Return unit to factory for repair.
“LOAD CLIP” alarm | a, Anti-free flow clip not installed. . Insure Clip is fully seated.
(Optional w/Anti-Free | b. Clip sensor inop. . Return to factory for repair.
Flow Clip) .
a, Solution spill in sensor area . Clean sensor area and tubing in
sensor area.
Constant “CLR
OCCL” alarm b. Wrong IV set(s) . Check for correct manufacturer’s
tubing type and manual for
acceptable catalog numbers.
Constant “CLR AIR”
of nuisance air alarms
or “CHK TUBE”
alarm
a. Dried solution in sensor area
b. Wrong IV set
c. Pumped on section of tubing loaded
Clean sensor arca with aqueous
type cleaner. Remove residue
with an alcohol wipe.
. Check for correct manufacturer’s
tubing type and this manual for
acceptable catalog numbers
. Move IV tubing up 8” and reload
in front of sensor fresh tubing in IV pump.
a. Excessive line noise ‘ Check AC line for noise
b. Electronic interference . Move unit away from offending
“PUMP FAIL” alarm interference.
6. Parts failure Return unit to factory for repair.
“MULT FAIL” alarm a. Motor not running at proper rate |
. Reference “Test Mode Procedure”,
step #3 Motor Oscillator Test. If
within specifications, return to
service. If out of tolerance, return
to factory.
“RATE ERR” alarm
a. User attempted to set RATE <I
mi/br
b. User attempted to set RATE >
maximum setting.
See “Program Options” section 4.
See “Program Options” section 3.
Section 1 Page 24