78
www.sigmasport.com
6 CALIBRATION AND CORRECTION FACTOR
6.4.2 CARRYING OUT CALIBRATION RUNS
1 Always start 20 meters from the starting line of the measured
distance (flying start).
2 As you cross the starting line, press the START/STOP button.
The measurement for the slow calibration run begins.
3 After you have run the measured distance,
press the START/STOP button again.
4 Now adjust the displayed value to the actual distance run by
pressing the PULSE (-) or SPEED (+) button.
5 Press the SET button. The slow calibration run is saved.
6 The alternating prompt “Run (walk) fast/press Start” now
appears on the display. Repeat steps 1– 5 to calibrate the fast run.
Note: After you have performed the first calibration, the calibration
menu will change. If you re-access it, you can distinguish between the
following options at the start: ON, OFF and NEW. Select ON to run
in training mode with calibrated values. Select OFF to run with an
uncalibrated RC 14.11. Select NEW to re-calibrate the RC 14.11.
To Next Page
Loading...