Sigma RC 14.11 - Connecting to Docking Station Watch

91
US/GB
9 DATA TRANSFER
9.1 CONNECTING THE RC 14.11 TO THE DOCKING STATION WATCH
Prerequisites: the SIGMA DATA CENTER has already
been installed and the docking station watch is con-
nected to your computer via a free USB port.
The docking station watch has an LED that helps you
correctly connect the RC 14.11. The LED illustrates
the following situations:
Solid red: docking station watch is
connected to your computer.
Solid green: you have correctly connected
your RC 14.11 to the docking
station watch.
Flashing green: the data is being transferred
from the RC 14.11 to the
SIGMA DATA CENTER.
Tip: if you need help operating the SIGMA DATA CENTER,
you can access the online help by clicking the button
with the question mark (found in the bottom left-hand
edge of the software).
Note: once all data has been transferred, remove your
RC 14.11 from the docking station watch to protect
its battery.