C-IPC 171 C-DIAS IPC WITH AMD FUSION G-T56N
Page 16 04.11.2019
5 Setting C-IPC Parameters with the SET Button
(under LASAL operating system only)
To enter the mode to change settings, press and hold the SET button while the C-IPC is
booting
When the following display appears
The SET button can be released.
The upper section of the display shows which setting can be changed; the lower section of
the display shows the set value.
The blinking part of the display can be set with a short press of the SET button:
If the upper section is blinking, the various settings can be viewed by quickly pressing the
set button multiple times. To change between the setting and the value, the Set button must
be pressed for about 1.5 s.
Once the desired changes are made, press the SET button for about 5 seconds to end the
process. If the changes are to be discarded, press the RESET button to restart the C-IPC
The settings for the IP address, subnet mask and gateway are hexadecimal, whereas in the
left and right digits, 0 - F must be entered separately. The changeover is triggered by press-
ing the SET button for about 1.5 s
The values from AUTOEXEC.LSL are used as the standard settings; changes are written
back to this file. Before this, the original content of the file is written to AUTOEXEC.BAK.
To Next Page
Loading...