SIGMATEK C-IPC 171 - Page 39

C-DIAS IPC WITH AMD FUSION G-T56N C-IPC 171
04.11.2019 Page 37
Solution:
- This depends on the cause
72
S-DIAS ERROR
A connection error with an S-DIAS
module has occurred.
Possible Causes:
- real network does not match the
project
- S-DIAS client is defective
Solution:
- analyze log file
73
EEPROM
ERROM
While reading the CPU EEPROM, an
error has occurred.
Cause:
- Access to I²C has failed
multiple times due to an error
or hardware defect
Solution:
- Restart the CPU
- After repeated failure
exchange the CPU
75
SRAM ERROR
An error occurred while initializing,
reading or writing SRAM data.
Possible Causes:
- SRAM configured incorrectly
- Battery for powering the internal
program memory is empty
Solution:
- Analyze log file (Event00.log,
Event19.log)
- check configuration
- Exchange battery for powering
the internal program memory
97
USER DEFINED 2
User-definable code.
98
USER DEFINED 3
User-definable code.
99
USER DEFINED 4
User-definable code.
100
C_INIT
Initialization start; the configuration is
run.
101
C_RUNRAM
The LASAL project was successfully
started from RAM.
102
C_RUNROM
The LASAL project was successfully
started from ROM.
103
C_RUNTIME
104
C_READY
The CPU is ready for operation.