RBW Range 1.5kHz to 800kHz
VBW Ratio 1 (VBW not selectable)
6.5 Zero Span (IQ Streaming)
IBW 40MHz (all models, all frequencies)
160 MHz (SM200B/C above 650 MHz)
Frequency Range 100kHz to 20GHz / 43.5GHz
Sample Rate 12.2kS/s to 50MS/s (all models)
(Base 50MS/s decimated by powers of two up to 4096)
250 MS/s (SM200B / SM435B)
100 MS/s, 200 MS/s (SM200C / SM435C)
BW Selectable, arbitrary.
(Sample rate * 0.8) maximum bandwidth.
7 SM200 Specifications
The following specifications are based on a set of operating conditions, which are the power-up
default settings, unless otherwise stated: 1) Operating in the Preset condition, 2) Using internal
timebase, 3) Video processing set for average and power, 4) VBW, sweep, gain, and attenuation
in the default auto mode, 5) Optional preselectors bypassed. 6) Ambient room temperature (18 -
28C)
IP2 and IP3 testing is performed at a -10 dBm reference level with preselector on, and normalized
to a 0 dBm reference level, which is the functional equivalent of 0 dB RF gain, or the “preamplifier
off” setting of a typical receiver. At maximum sensitivity (-20 dBm reference level), IP2 and IP3
will typically be 20 dB lower.
DANL is tested at maximum sensitivity (-20 dBm reference level)
Frequency Range 100 kHz to 20 GHz
RF Input Impedance 50Ω Nominal
(type-N connector)
4
Calibrated Streaming I/Q 5 kHz to 40 MHz of selectable I/Q bandwidth.
Resolution Bandwidths (RBW) 0.1 Hz (≤200kHz span) to 3MHz (any span) using the
40MHz IBW
30kHz to 10MHz using the 160MHz IBW
Timebase Accuracy GPS disciplined OCXO remains within ±5 x 10-10 when
locked to GPS;
Holdover of ±5 x 10-9 per day for aging
To Next Page
Loading...
Need help?
General
