9.51 lbs. (4.31 kg) active cooling (Option 1)
Power Consumption 22 watts (when idling) or 32 watts (when sweeping or
streaming I/Q) sourced from the AC wall adapter which
is included or from an external supply of 9V to 16V when
using the Option-12 LEMO Pigtail.
1
Dynamic Range is defined here as ⅔ of the difference between IP
3
and DANL as measured in ITU-R
SM.1837, normalized to dB/Hz
2
For EVM measurements of signals having symbol rates between 100 kHz and 1MHz. The SM200A/B
will contribute a somewhat higher EVM error for symbol rates outside of this range.
4
Streaming I/Q and burst I/Q are bandwidth limited to the speed of the available Ethernet connection.
5
DANL, Residual Responses, Spurious Mixer Responses, and Phase Noise specifications are production
tested and guaranteed only at 23°C (±5°C). Typical performance of these characteristics, over the
instrument’s operating temperature range, will be published as graphs in the User’s Manual.
6
The SM200 length is 10.97” (0.77” longer) when counting the front panel type-N RF input connector and
0.375” higher when counting feet.
9 Warranty and Disclaimer
©2013-2020 Signal Hound. All rights reserved.
Reproduction, adaptation, or translation without prior written permission is prohibited, except as
allowed under the copyright laws.
9.1 Warranty
The information contained in this manual is subject to change without notice. Signal Hound makes
no warranty of any kind with regard to this material, including, but not limited to, the implied
warranties or merchantability and fitness for a particular purpose. Signal Hound shall not be liable
for errors contained herein or for incidental or consequential damages in connection with the
furnishing, performance, or use of this material. This Signal Hound product has a warranty against
defects in material and workmanship for a period of two years from date of shipment. During the
warranty period, Signal Hound will, at its option, either repair or replace products that prove to be
defective.
9.2 Warranty Service
For warranty service or repair, this product must be returned to Signal Hound. The Buyer shall
pay shipping charges to Signal Hound and Signal Hound shall pay UPS Ground, or equivalent,
shipping charges to return the product to the Buyer. However, the Buyer shall pay all shipping
charges, duties, and taxes, to and from Signal Hound, for products returned from another country.
To Next Page
Loading...
Need help?
General
