Water Outlet
Extension Hose
How to Drain Excess Water From Hoses
Start of dishwasher
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
Attention:
-52-
If the sink is more than1000 mm higher than the floor, the excess water in hoses
cannot be drained directly into the sink. It will be necessary to drain excess water
from hoses into a bowl or suitable container that is held outside and lower than the sink.
Connect the water drain hose. The drain hose must be correctly fitted to avoid water
leaks.
Ensure that the water drain hose is not kinked or squashed.
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres,otherwise the cleaning effect of the dishwasher
could be reduced.
The following things should be checked before starting the dishwasher.
1. The dishwasher is level and fixed properly.
2. The inlet valve is open.
3. Inlet hose connections are fully tightened and not leaking.
4. The wires are tightly connected.
5. The power is switched on.
6. The inlet and drain hoses are not kinked.
7 All packing and print materials should be taken out of the dishwasher.
To Next Page
Loading...
Need help?
General
