OPERATING INSTRUCTIONS
STRAP TENSION
Failure to use the proper strap/seal/tool
combination for the load being strapping
can result in an improperly secured load
which can result in severe personal
injury. If you have any questions, contact
your local Signode Representative.
Strap tension is controlled by setting the control
on the rear of the tool. Adjust the tool to give the
desired tension level. Rotate the tension control
clockwise to increase strap tension.
Once the tool has been set, tension will be uniform
on all straps provided the operator allows the
motor to stall.
TENSION LBS. (NEWTONS)
10
To Next Page
Loading...
