TRAINING
Read the operating instructions carefully. This tool must not be used by persons not
properly trained in its use. Be certain that you receive proper training from your
employer. If you have any questions contact your Signode Representative.
EYE INJURY HAZARD
Failure to wear safety glasses with side shields can result in severe eye injury or
blindness. Always wear safety glasses with side shields which conform to ANSI
Standard Z87.1 or EN 166.
CUT HAZARD
Handling strap or sharp parts could result in cut hands or fingers. Wear protectiv e
gloves.
SOUND PROTECTION
When operating the tool, wear ear protection.
ENVIRONMENTAL PROTECTION
Charger and batteries should be sorted for environmental-friendly recycling. Do not open
the battery. Do not throw the used battery into household waste, fire or water.
DISPOSAL
This tool is manufactured without any physical or chemical substances which could be
dangerous to health. The legal prescriptions for disposal of all the parts must be
observed. The electrical assemblies should be dismantled so tha t the mechanical,
electro-mechanical and electronic components can be disposed of separately .
DO NOT USE WATER
Do not use water or stream to clean the tool.
POWER SOURCE
Before starting preventive or corrective maintenance, remove the battery from the tool.
Always inspect the electrical plug and cable on charger before use. If damaged, they
must be replaced by qualified personnel.
4
To Next Page
Loading...
