Water supply temperature
°C
Max 30
Water supply hardness
°F
7 – 12
Water supply pressure kPa 200/400
Rinse cycle water consumption at 200 kPa l 2,4/2,6
Wash water temperature
°C
50 - 60
Rinse water temperature
°C
82 - 85
Net weight kg 82
Ambient temperature max
°C
40
Power cable type
◄HAR►
H07RN-F
• Do not use old water filling hoses, but exclusively new filling hoses.
• The following fundamental rules must be observed when using this appliance:
1) Never touch the appliance with wet hands or feet.
2) Never use the appliance with bare feet.
3) Do not install the appliance in workplaces where it could get sprayed/splashed with water.
• Do not put your bare hands into water containing detergent. If you do, wash them thoroughly under running water straightaway.
• Strictly follow the manufacturer’s instruction handbook for the cleaning operations.
• This appliance is designed to work in a workplace with a maximum ambient temperature of 40°C, in a suitable area where the temperature is never lower than 5°C.
• Do not use water to extinguish fire on electrical parts.
• After disconnecting the power supply, only qualified personnel may access the control panel.
• The machine has a protection rating against accidental water splashes of IPX1; it is not protected against pressurised water sprays; you are therefore recommended not to use pressurised cleaning systems.
ATTENTION: YOU MUST WAIT 10 MINUTES AFTER SWITCHING THE MACHINE OFF TO CLEAN IT INTERNALLY.
ATTENTION: IT IS FORBIDDEN TO PUT YOUR HANDS INTO THE TANK AND/OR TO TOUCH THE PARTS AT THE BOTTOM OF THE TANK DURING AND/OR AT THE END OF THE WASH CYCLE.
NB: The manufacturer declines all forms of responsibility for personal injuries or damage to property deriving from the failed observance of the instructions given above.
INSTALLATION GENERAL WARNINGS
If the electrical and plumbing systems have to be adapted to install the machine, these modifications must be
carried out by authorised professionals.
• Glass and dishwasher are professional machines. It must be used by adult and authorised personnel. It must be installed and
repaired exclusively by a qualified technical assistance service. The manufacturer declines all forms of responsibility for improper use,
maintenance and repairs.
• Make sure the machine does not sit on the power supply cable or on the filling and draining hoses. Adjust the support feet of the
machine to set it level.
• The user must not carry out any repairs or maintenance work on the machine. These jobs must be carried out by qualified and
authorised personnel.
• Any assistance required on this machine must be carried out by authorised personnel.
ATTENTION: Use exclusively original spare parts, otherwise the product warranty issued and the manufacturer's responsibility will
become void.
ALWAYS UNPLUG THE MACHINE FROM THE MAINS SOCKET BEFORE STARTING ANY MAINTENANCE WORK. IF THIS IS NOT POSSIBLE, IF THE MAINS SWITCH IS HIDDEN BEHIND THE MACHINE OR FAR
AWAY FROM WHOEVER CARRIES OUT THE WORK, YOU MUST PUT UP A SIGN ON THE EXTERNAL MAINS SWITCH AFTER TURNING IT OFF TO WARN OTHERS THAT MAINTENANCE WORK IS IN PROGRESS
10/05/2019 4
To Next Page
Loading...
