15
11 ELECTRICAL CONNECTION
The electrical connection must be carried out according to technical standards currently in force.
Make sure the measured mains voltage matches that written on the technical data nameplate of the machine.
You have to fit an appropriate omnipolar protection circuit breaker switch suitable for the input of the machine.
This switch must be used exclusively for this utility and installed right next to it. Make sure the electrical systems are suitably earthed.
The machine also has a connection, at the rear bottom part, marked with the equipotential symbol that is used to connect various appliances together equipotentially (check
standards on electrical systems).
BE CAREFUL NOT TO INVERT THE PHASE WIRES WITH THE NEUTRAL WIRE, WHILE CONNECTING TO THE POWER OUTLET.
IF THE POWER SUPPLY CABLE SHOULD GET DAMAGED, IT MUST BE REPLACED EXCLUSIVELY WITH A NEW ONE FROM THE MANUFACTURER OR FROM AN AUTHORISED SERVICE
CENTRE AND BY QUALIFIED TECHNICIANS.
16
10/05/2019 8
To Next Page
Loading...
