9 WATER CONNECTION
Make sure the dynamic pressure of the mains water is minimum200 kPa to ensure the perfect operation of the machine.
The temperature of the supply water must be maximum 30°C
Each machine is supplied with 2 water filling hoses with threaded 3/4”fitting.
The drainage hose is to be connected, after adding a siphon, directly to the drains.
Do not fit the drain hose into the drains of sinks, bathtubs etc.
Make sure the water hardness is between 7 and 12°f, otherwise install a water softener to prevent damages caused by scale, which are not covered by warranty.
WITH DRAIN PUMP WITHOUT DRAIN PUMP
9.1 DRAIN
The drainage hose is to be connected, after adding a siphon, directly to the drains.
The water falls freely into the drains, therefore the point where it is connected to the drain outlet must always be below the level of the wash tank.
If the existent drain point is above this level, a suitable drain pump has to be installed (optional). Do not fit the drain hose into the drains of sinks, bathtubs etc.
9
10/05/2019 5
To Next Page
Loading...
