Silca Air4 Home - ADMINISTRATOR PIN HANDLING; DEVICE RESET AND FACTORY RECOVERY; EXTERNAL POWER SUPPLY CONNECTION

Air4 Home-Air4 Home PRO
Copyright Silca S.p.A 2019
English
13
10. ADMINISTRATOR PIN
When the device is fi rst switched on or reset (see the chapter 11), the device will prompt the user to choose
an 8-digit PIN via the app. The user can enter the PIN of their choice and use this PIN to access the Air4 Home
administrator func ons.
The PIN must therefore be safely stored by the owner of the Air4 Home, as it may be required if for
example, the user changes the smartphone that had previously been used to log in as an administra-
tor. The Air4 Home app provides the user with the option to securely save the PIN on the Silca Server,
by simply providing a recovery email address.
In the event that the PIN is no longer available or recoverable, the user must reset the device; this will erase
all the defi ned se ngs, such as the saved remote controls and authorised users.
11. DEVICE RESET
ATTENTION: The device reset allows the user to reset the Air4 Home to its factory se ngs, which in turn
deletes all the data.
PROCEDURE:
- Access the ba ery compartment by loosening the two screws on the internal shell (Fig./Abb.7)
- Hold down the Reset key (Fig./Abb.3) for approximately 10 seconds.
- Release the key only when the LED starts fl ashing more rapidly.
- Wait a few minutes for the device to complete the Reset opera on.
- The opera on will be terminated only when the LED will start fl ashing regularly (1 fl ash every 2 seconds).
12. UPDATING THE DEVICE
Air4 Home can be upgraded to a more recent fi rmware version using the Easy Scan Plus so ware (Air4 pro-
gramming so ware), which is available from the www.silca.biz website, and an adapter that is sold separately
.
13. EXTERNAL POWER SUPPLY
WARNING : THIS OPERATION MAKES SUBSTANTIAL CHANGES TO THE DEVICE AND MUST
ONLY BE CARRIED OUT BY QUALIFIED TECHNICAL PERSONNEL.
WARNING (TRIANGLE): The external power supply is an alterna ve to ba eries, and there-
fore the ba eries must be removed
.
The device can be powered by a power supply capable of supplying 5VDC and a minimum of 500mA.
A normal Smatphone charger has all the necessary features.
Required tools (not supplied with the device):
- Fairlead.
- External 5VDC power supply.
- Drill or other tool suitable for drilling.