Silca MARKER 2000 - Page 2

located on your keyboard. Select a marking
zone from the eight available on the tracking
disk (D1) Rotating this disk will display the
different images available (See Fig. 3). At this
time, ensure the number of the zone selected
(See Fig. 4) is displayed on the tracking infor-
mation screen of the Marker 2000 display.
The + and - keys on the keyboard change the
selection. When correct, press <F10>.
7. Press <F7> for text entry and four lines are
displayed. By pressing enter after keying in
the desired information you can move down a
line. When you have completed the text press
<F10>.
8. Turn the clear plastic slide back off the jaw. If
the information displayed is correct push the
jaw back to the in (Marking) position (See
Fig. 5) until it
locks in place.
Press <F10>
for Marking. If
a problem
occurs during
marking,
action may be
halted by
pressing the
<ESC> key.
9. After the job is
completed,
select the <ESC> button to set up the next task.
If you wish to save the original information
select “Y” for yes and this file will be saved
under the name you select. <Press F10>. This
file name is then listed under “Local Marking”.
To access this file at a later time, select <F2>
(List of Models). At the screen display listing
all models, pressing <ESC> will allow you to
start a new job. If you select “N” for No, you
will be at Step 4 of this guide.
10.Refer to the Troubleshooting section on page
four of this guide if problems are experienced.
If the problem is not listed, check the opera-
tions manual or contact technical support at
Ilco Unican.
SPECIAL MARKING
You may change either direction or orientation of
your marking. At the marking information screen
(See Fig. 6) press the tab key on your keyboard
until you reach
the selection you
wish to change.
Press the space
more for the
desired direction
or orientation. Options available are illustrated
in Fig. 7.
When selections have been made, continue at
Step 5 of this guide.
2
Fig. 5
Fig. 4
Slide = 3
Side = LH
Dire. = Hor
Pcs. = 1 of 1
Clamp = C1
Orie. = 0
AutoF - [x]
Fig. 6
SILCA
SILCA
SILCA
SILCA
SILCA
S
I
L
C
A
0 90 180 270
HORIZONTAL VERTICAL
direction:
orientation
Fig. 7