5
System Override/Valet
A patented removable switch is used to override the security system in the event that the transmitters are lost
or fail to operate and to put the security system in non-operational mode (valet) for vehicle servicing, etc.
Override Operation (Security system is armed)
1. Enter the vehicle, the security systems will begin sounding at this point, and place the override switch
into the switch housing. Make sure that the switch button is in the “Out” position.
2. Place the ignition key into the ignition switch and turn the ignition switch to the “On” position.
3. Within 5 seconds of turning the ignition key “On”, press the valet switch button “In” until it locks.
4. The horn/siren will stop sounding.
5. The LED indicator will be solid red.
The security system is overridden and is now in the valet mode.
Valet Operation (The security system is already disarmed)
1. Place the valet switch into the switch holder making sure that the switch button is in the “Off” position.
(Switch button is out)
2. Turn the ignition key to the “On” position.
3. Within 5 seconds of turning the ignition key “On”, push “In” the valet switch.
4. The LED will be on solid indicating that the security system is in the valet mode.
Note 1: If the valet switch is already in the “On” position when you turn “On” the ignition key, the valet
function will be bypassed. Turn “Off” the ignition key, set the switch to the “Off” position and try again.
Note 2: If you fail to push “In” the valet switch within 5 seconds of turning “On” the ignition key, the valet
function will be locked out. Turn “Off” the ignition key, set the switch to the “Off” position and try again.
Starter Disable
Your Silencersecurity system has a built-in starter interrupt relay that will break the connection between
your ignition key and the starter on your vehicle. To test this feature, repeat the following steps:
1. Enter the vehicle and close all entrances.
2. Press the “Lock” button on your keyless entry transmitter to arm the security system.
3. Place the ignition key into the ignition switch and try to start the vehicle. The starter will not crank the
engine over.
4. Turn “Off” the ignition key and press the “Unlock” button on your keyless entry transmitter to disarm
the security system.
5. Attempt to start the engine again. The starter will now engage and the engine will crank over and run.
Note: The removable valet switch can only be
inserted into the valet switch housing one
way. Do not force the switch or bend the
switch terminals.
Primary Feature Operations (Continued)
7959PUM.qxp 6/3/05 14:58 Page 5
To Next Page
Loading...
