OSIRIS INSTALLATION GUIDE
Commercial in Confidence 4/26
INSTALLATION SHOULD BE CARRIED OUT BY QUALIFIED PERSONNEL ONLY IN ACCORDANCE WITH THE
APPLICABLE LOCAL CODES.
THE MANUFACTURER CAN ACCEPT NO LIABILITY FOR ANY DAMAGES OR LOSSES CAUSED DUE TO
INCORRECT OR IMPROPER INSTALLATION.
Safety Information
Before installing the equipment, please read this guide carefully.
Installation of this product should only be carried out by a competent and suitably qualified
engineer. If you are in doubt, you should refer the installation to a suitably qualified person.
To prevent electrical shock hazards, disconnect the power from electrical sources before working
on the equipment.
Make all connections with the power turned off. Do not make or remove connections when the
power is turned on. Before using the product ensure that all cables are correctly connected and
that the power cables are not damaged.
Ensure that the product is secured correctly in all situations. Do not place the equipment on to a
trolley, table desk or other platform that is not stable; to avoid the product from falling over.
Ensure that the power supply to be used is correct for the equipment and the correct input voltage
for your region. If unsure, contact your local power supply company. If the power supply or cables
are broken, do not use them. Contact a qualified electrical services technician or your retailer.
1. Do not use any equipment that appears damaged or incomplete. If you detect damage,
contact your dealer immediately.
2. Do not allow connectors to be exposed to long-term water immersion.
3. Do not allow electrical contacts or leads to be exposed to dust, humidity or moisture. Do not
allow electrical contacts or cable-ends to become wet.
4. The equipment must be firmly secured using appropriate fixings and fastening as
appropriate to the mounting surface that the unit is being affixed to.
Notes:
1. Do not open the camera unit, doing so invalidates the unit’s warranty.
2. Do not back-drive the pan or tilt axis of the camera. To do so will damage the motor drive
mechanism and will invalidate the warranty.
3. Do not use caustic or abrasive cleaning products on the unit.
4. In situations where there could be a risk of injury should any part of the assembly become
detached for any reason and fall, normal safety precautions should be employed.
5. Use only the power source types indicated in this user guide or provided with the unit.
6. All power supplies should be appropriately fused.
7. Take extra care lifting or moving units due to their weight.
8. The central PT unit should be installed by itself with no payloads attached. The
camera/sensor and Radar payloads fitted individually, after it has been secured.
9. Take care to allow space around the unit for Pan and Tilt motion.
10. Take care to avoid striking persons or objects when the camera is in motion.
11. Not fitting the provided sun shields will invalidate the systems warranty.
12. This guide only concerns itself with the Mechanical Installation of the System.
To Next Page
Loading...