2. USING YOUR 3D AS A PRAM
8
Now attach your apron to the press studs
inside the hood to enclose the pram.
Your 3D Pram System is now ready for use.
Warning: Do not add a separate
mattress
Now fit your hood facing towards the
handles. The hood catches easily 'click' onto
the 3D and lock the catch down. Position the
rear hood skirt under the leg support joint.
Now pull the liner over the bumper bar, and
under the leg support. The liner will attach
with velcro underneath the leg support.
14
13
15
To Next Page
Loading...
