Silver Cross Linear Chassis - Using Your Linear with the Ventura Car Seat

10
To attach your Ventura car seat to the
Linear chassis, hold the car seat centrally
over the chassis mounting bars
7. USING YOUR LINEAR WITH THE VENTURA CAR SEAT
To disengage the Ventura, there is a release
handle on the rear of the car seat, pull this
upwards whilst holding the car seat by the
handle.
You can now lift the Ventura off the chassis.
On the underneath of the Ventura are four
locking points, lower the car seat onto the
Linear mounting bars so that these locate
and ‘click’.
Gently lift the car seat to ensure it is fully
locked on to the chassis.
23
22
24
Linear Pushchair 031204 13/5/05 7:18 am Page 10