silvercrossbaby.com
ENG
FRA
SPA
ITA
DEU
SWE
FIN
RUS
ZH-S
ZH-T
ARA
9
Motion
360° i-Size Car Seat
360° i-Size Car Seat
40cm - 105cm / Birth to 18kg (approx 4 years old)
INSTALLING THE CHILD SEAT
TO INSTALL THE MOTION CHILD
RESTRAINT SYSTEM FOLLOW THE STEPS
BELOW:
1.1 Unfold the support leg (12) until it is
in the vertical position as shown.
1.2 Move the button (11) to slide the
ISOFIX connector arms (9) backwards
unfolding the connector fully. Do this for
both connector arms.
1.3 Guide the connector arms towards
the ISOFIX anchors in your vehicle until
they lock together by clicking into place
and the indicator changes from red to
green on both sides of the base.
1.4 Move the seat backwards pressing
the backrest against the vehicle seat.
Then pull the safety seat towards you to
check that it is securely locked in place.
1.5 Press the button (13) to adjust the
height of the support leg (12) until it
is rmly in contact with the oor. It
should not be on top of any type of
compartment. At this point make sure
that the support leg is at 90 degrees to
the safety seat.
The visual ISOFIX indicators show
whether the connector is open or closed.
It may be that the connector is closed
but not locked into the ISOFIX anchor.
Please check that all the connectors are
correctly locked into the vehicle anchor
points by pulling the seat once it is
installed.
TO DETACH THE SEAT FOLLOW THE
SAME STEPS IN REVERSE:
1.6 Move the button (10) to open the
connector and release it from the
anchor point.
To Next Page
Loading...
Need help?
General
