Installing and removing the
Simplicity Infant Carrier (cont)
Using a 3 point lap and diagonal seat
belt to install the Simplicity Infant
Carrier (cont)
23 Check that the angle of the
Simplicity Infant Carrier back rest
is not too upright and make sure
that the seat belt is not twisted.
Push rmly into the back of the
Simplicity Infant Carrier, it should
feel tight and secure. There should
be no excessive movement forward
or to the side.
NOTE: The seat belt guides are
colour coded BLUE because it is
a REARWARD FACING ONLY
child restraint.
Removing the Simplicity Infant
Carrier from the vehicle
Remove the diagonal section of the seat
belt from the blue diagonal belt guide.
Unfasten the seat belt and remove the
belt out of the blue lap section guides
taking care to hold the seat belt away
from your baby. Carefully remove the
Simplicity Infant Carrier from the
vehicle using the carry handle in the
upright carry position.
Make sure the handle has CLICKED
into the correct position.
23
16
To Next Page
Loading...
Need help?
General
