7
SHSS 12 C2
GB
Operation
ATTENTION! MATERIAL DAMAGE!
►
The suction opening must always be open and
unblocked. Blockages lead to overheating and
damage to the motor.
► Do not vacuum shag pile carpet with the floor
nozzle. The rotary brush . can get caught in
the carpet and block!
NOTE
► Make certain that the dust filter and the
coarse filter are always inserted before
using the appliance.
► As soon as the suction power of the appliance
begins to diminish noticeably, connect the
appliance to the charger %.
Using the hand element with the
handle
1) Insert the hand element into the hand
element recess ! as described in the chapter
“Assembly/disassembly”.
2) Fold out the grip by pressing the “Grip”
release - and at the same time pulling the
grip upwards.
3) Switch on the appliance using the on/off
switch . The LED lamp 0 on the floor nozzle
will illuminate and the rotary brush . starts
turning.
4) Guide the floor nozzle over the area to be
vacuumed. Hold the grip so that the floor
nozzle moves smoothly over the floor.
5) Press the on/off switch when you have
finished vacuuming. The rotary brush . stops
and the LED lamp 0 goes out.
Using the hand element
1) Remove the hand element from the hand
element recess ! as described in the chapter
“Assembly/disassembly”.
2)
If r
equired, attach the crevice tool 1 or the
brush nozzle 6.
3) Set the on/off switch to start vacuuming the
desired areas.
4) When you have finished vacuuming, press the
on/off switch again.
Cleaning and care
WARNING! RISK OF INJURY!
► Always disconnect the charger %from the
mains socket and remove the barrel jack +
from the charging socket / on the cradle
before cleaning the cradle .
► Always remove the hand element from the
hand element recess ! on the handle before
cleaning the hand element , the handle or
the rotary brush ..
To achieve the best results, empty the dirt container
and clean the dust filter after every use.
ATTENTION! MATERIAL DAMAGE!
► Do not use abrasive or aggressive cleaning
materials. These could damage the surface
of the appliance!
NOTE
► The LED lamp 0 is maintenance-free.
The LEDs cannot be changed.
To Next Page
Loading...
