EasyManua.ls Logo

Silvercrest 346881 2001 - Functions; Welding a Tube Film

Silvercrest 346881 2001
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8 
GB
IE
NI
CY
SV 125 C3
Functions
Button Function
w
Activate/deactivate additional function "wet"
(for particularly moist food products)
e
Start/cancel "external vacuuming" function
(for vacuuming using the hose and adapter)
r Start/cancel "sealing" function (without vacuuming)
t Start/cancel "vacuuming and sealing" function
Soft
z
Activate/deactivate additional function "soft"
(for pressure-sensitive foods such as fruit or cakes)
Welding a tube film
NOTES ON THE FILM
The film width may not exceed 30 cm. Otherwise it cannot be welded
correctly.
Use only nylon PA/PE films with a structure (dots or grooves) on one side
and a thickness of approx. 0.17–0.29 mm (170–290 μ) in this device.
Otherwise, the weld seam will not be tight and the appliance may be
damaged. You can recognise films of this type from the information on the
packaging. The quality of the weld seam will vary depending on the type
and thickness of the film.
The supplied film is suitable for temperatures between -20°C and +110°C.
The supplied foil is BPA-free and microwaveable. However, never heat
completely sealed bags in the microwave. The bag could burst! One side
of the bag must be open. Heat the bags for no more than 3 minutes at a
maximum temperature of 70°C.
1) Cut the desired length for your bag from the tube film using a pair of scissors.
Cut as straight as possible.
2) Open the appliance lid 1 by pressing the lid release 8 and opening the
lid 1 upwards.
IB_346881_SV125C3_LB6-.indb 8 15.05.2020 14:17:59

Table of Contents

Related product manuals